I’ve tried your device tree example as well as different examples found:. This doesn’t work for the Yukon 2 card however. I haven’t used Zynq before, so maybe this suggestion is not appropriate. Use of the information on this site may require a license from a third party, or a license from TI. If you need to reset your password, click here. Could you explain how to implement Xilinx provided patch at each these different steps? What I did was install warty first because the sk98lin driver there works.

Uploader: Zulkinos
Date Added: 3 April 2017
File Size: 17.23 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 51092
Price: Free* [*Free Regsitration Required]

Copyright c – Intel Corporation.

Linux source code: drivers/net/phy/marvell.c (v) – Bootlin

Add the phy handle to the gem sections: Do you have any further information about this question? See last few lines below! So you had to do this in order to get your network card to work in Hoary, is this correct? Bookmarks Bookmarks Digg del. By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features.


net/phy: Fix copper/fiber auto-selection for 88e1111 [Linux 2.6.27]

I will dig into the phy initialization code to see why 88e111 seems to ignore PHY1. I have looked at the following link, and it appears that the issue of supporting two PHYs was solved in It will be fixed in the Registration is quick, simple and absolutely free.

So I would suggest you to try testing the setup in July 13th, 7. We are not able to run our dual GEM config. I then grabbed all the debs I needed using the network before performing a standard upgrade to hoary. Anything is fair game. Note that I am using two different sub-nets – the Again, this appears to be a software issue.

Check the reset pin to the PHYs. Please upgrade to a Xilinx.

Asus mainboard with buggy VPD? Oct 1, This doesn’t work for the Yukon 2 card however. I cant try it due to my situation, if you try it can you please give information about Hope this helps everyone with this problem Any problems that I should be aware of?


However, eth1 still doesn’t work correctly. More info in my bugreport here for those who are linyx. I have confirmed this as I have the latter card.

Thanks for the advice.

Results 1 to 10 of On my system that causes a hang which I could not get out of. Cadence GEM rev 0x at 0xec irq FYI, the patch is here, but not applicable to any of the current Xilinx kernel releases: Reluctant to pursue it as we are not using Petalinux: Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter.

Written by