One page of printing has spread to two pages. If there is a ground wire at the end of the cable, attach it to the ground connector This gives you an 8. Printing Method Impact Dot Matrix. Attaching the paper supports You should install the paper supports before you begin using the printer. Set the shaft and paper roll onto the roll paper holder.

Uploader: Shakaramar
Date Added: 3 March 2015
File Size: 64.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 24038
Price: Free* [*Free Regsitration Required]

LQ – Software & Document – 24 Pin – Download – Dot Matrix – Epson

Using The Printer Software The monitoring settings are shown below. Hold another paper support and push the tips into the notches of the other side on the edge Turn the ribbon-tightning knob in the direction of the arrow to help feed the ribbon into place; it Using the Error Indicators You can identify many common printer problems using the lights on the control panel. To view a menu, click the corresponding tab at the top of the window.

The printer comes with epon tractor installed in this position.

If there is a ground wire at the end of the cable, attach it to the ground connector located to the right of the parallel interface port. Page The paper may have come off the tractor.

  BROADCOM NETXTREME GIGABIT ETHERNET PCI E ULD DRIVER

Pull the paper guide backward. You can also change settings on the Utility menu in the printer driver. This gives you an 8. Customer support in India Contacts for information, support, and services are: Download command is not provided.

Epson LQ-1150 User Manual

Page 76 Using the Printer Push the sprocket lock lever back to lock it in place. Next, tap the side and bottom of the paper on a flat surface to even up the stack. Turn on the printer. To print the manual completely, please, download it.

To monitor the printer, make sure the Monitor the printing status check box is selected. Hold another paper support and push the tips into the notches on the paper tension unit. When you resume printing, the printer automatically feeds the paper back to the The paper or ribbon Page of Go. Printable Area Printable area Single llq-1150, cards and envelopes: If epsoj self test works properly the problem probably lies in the computer, the application software, or the interface cable.

  J BLACKFOOT MR.BUS DRIVER DOWNLOAD

The procedure below describes the test using single sheets, which is the easier way. Reattach the paper to the tractor. The paper or ribbon may be jammed. The following tips will help you get good results: Options Options When you use the cut-sheet feeder, the paper does not feed properly The paper does not feed.

Insert the paper into the bottom paper oq-1150 or into the rear paper slot as shown below, and pull it up. High-speed printing of up to cps characters per second at 10 cpi characters per inch or cps at 12 cpi.

For multipart forms and labels, you should not print any closer than 13 mm 0. Raise it up, and then push it firmly until it fits in place. The Monitoring Preferences dialog box appears. Paper type Lever position Standard paper single-sheet or continuous Page

Written by
admin